how to sand a skatetboard

Take away the wheel vans with the appropriately sized wrenches and screwdrivers in your skateboard; set the apart. Relying in your skateboard, the vans is perhaps mounted with a mixture of screws, nuts and bolts

Peel away the grip tape on the highest of the board. It’s possible you’ll want a small quantity of adhesive remover to loosen the glue.

Sand the perimeters with an 80-grit sanding block to attain a rounded form. Alternatively, you need to use a chunk of sandpaper wrapped round a picket block or a palm sander outfitted with a chunk of 80-grit sandpaper.

Brush the mud away with a clear brush. A clear, vast paintbrush works nicely for this.

Repeat the method of sanding the perimeters and brushing the mud away with the 120-grit, 180-grit and 220-grit sanding blocks. Whenever you end, the perimeters needs to be clean and completely rounded.

Sand the highest and backside of the skateboard with the 80-grit sanding block with lengthy even strokes, following the grain of the wooden. Sanding in opposition to the grain will stop you from attaining a clean floor.

Run your hand over the board to make sure that the floor is sanded evenly. Proceed sanding any areas of inconsistency till your entire board is even.

Repeat the sanding course of on the highest and backside of the board utilizing the 120-grit sanding block, then the 180-grit sanding block and ending with the 220-grit sanding block.

Paint a graphic design on the underside of the board and coat with two to 3 layers of protecting polyurethane.

Measure and apply a brand new sheet of grip tape to the highest of your board, being certain to push out all air bubbles as you go. You should purchase pre-measured sheets of grip tape with graphics from many skateboard outlets and on-line retailers.

Exchange the vans on the underside of skateboard

Cite this Article

Ideas

  • Palm sanders are comparatively straightforward to deal with, however you might want to make use of a sanding block for the tremendous element of the skateboard’s edges.

Issues Wanted

  • Wrenches
  • Screwdrivers
  • Adhesive remover
  • Clear brush
  • 80-grit sanding block
  • 120-grit sanding block
  • 180-grit sanding block
  • 220-grit sanding block
  • Paint
  • Grip tape

References

  • Artwork of Skateboarding: Step-By-Step Information to Deck Restoratioan
  • DIY Skate: How To Make A Skateboard Deck

Concerning the Writer

A former cake decorator and aggressive horticulturist, Amelia Allonsy is most at dwelling within the kitchen or along with her arms within the dust. She obtained her Bachelor’s diploma from West Virginia College. Her work has been printed within the San Francisco Chronicle and on different web sites.